Laying holes in drywall

Laying holes in drywall. Those who sutured the walls of the wall or made partitions from it, are faced with the fact that holes may appear on it, from which you should get rid of. Such holes may appear from a sharp opening of the door, or when rearranging furniture. In order to eliminate such holes, you need to perform the following actions: • You need to take the right size a piece of drywall, which can easily close the hole in the wall.

Note: If you are interested in an electrician call to your home, we advise you to visit the Remonter-MSK website. . On this site, you can call a high -class specialist at home without leaving your home. Employees of this company have high degrees of admission that eloquently speaks of their experience and reliability of the work they did.

But when choosing such a piece, it must be borne in mind that it should be exactly the same width that it was used before. Then it must be attached to the deformation site and mark the pencil. • Then the marked area is carefully cut out using a stationery knife. • When the necessary area is prepared, then we attach a piece of a wooden bar on its back wall, which will need to be fixed using ordinary screws. • Then we attach your measured piece of drywall to this bar to this bar. • After that, the joints should be smeared with putty and yes dry. • After drying, this area is well wiped with sandpaper and is sealed with the same material as all other walls.

Thanks to such actions, the place where the hole was on the wall will not be visible, and you will not need to spend a lot of money without making such small troubles.