Window and door blocks in the stone walls are installed on the plumb line. The ledge for the line of the quarter of the opening should be the same around the entire perimeter of the box. The planes of blocks facing brickwork should be covered with antiseptic paste and covered with a layer of vapor barrier. The block in the opening is regulated and temporarily fixed with wedges. After the reconciliation, the block is fixed with ruffs (crutches) to plastic or wooden traffic jams mounted in the walls during their masonry or anchors. The distance between the mounting places in the height of the block should not exceed 1.5 m. The cracks between the blocks and the wall are thoroughly hemping, felt or mineral wool, dump with mounting foam. On the outside, underground waterproofing is equipped along the perimeter of the unit, vapor barrier, to prevent moisture condensation in the seams. The door blocks in the partitions are installed so that the width of the box is equal to the width of the plastered partition. The fastening is carried out by ruffs and anchor mounts directly to the partition or to traffic jams, which are driven into the holes of the slabs. The cracks between the partition and the door frame are thoroughly hemp and blow out with construction foam. The platbands in places of joints are cut into a mustache and confused or screwed to the door frame after plaster. The lower part of the platband is based on the base, which is installed on the floor. The base has a height of 150-200 mm. A skirting board or filler is attached to the rear end of the basement. Door and window fittings: handles, locks, valves, limiters, spinger are cut to blocks during construction; window to glazing windows, door – before painting. Furniture (Buke) is attached to the windows or doors with screws. The use of nails for this purpose is prohibited. Screws are screwed up by a screwdriver for at least 3/4 screws. Fastening devices with screws into the end of the bar (along the length of the fibers) is not allowed.
Leave a Reply