Gluing drywall

Gluing drywall

This method of installation of drywall is cheaper than installation on the profile, as the cost of profiles is deducted.

And also allows you to save space on the thickness of the profile – 3 cm. It is enough to seal the wall with drywall

simply.

For work, we will need: a pack of dowel-gvo 660, glue (putty) fugen-fuller,

or a mixture of starting putty with finish. Tools: punch with a diameter drill 6 mm, rule (or flat rail)

1.5-2 m long, accurate level or plumb line, low thread 30 m, hammer.

So let’s get down. First you need to put it on the level of the beacons, for which we will use the dowel-gvo.

In the corners of the wall (side corners), we alternately hang the plumb line, inhabit the holes after about a meter, score dowels,

then nails, IT adjust them along the plumb line. Hats of nails should stand along a thread with a small gap of 1-2 mm. Similar

The procedure can be done using the level.

Then, along the finished extreme beacons (hats of nails), pull the threads along the length of the wall and lay the holes from the calculation

3 dowel-clasp per 1 sheet of drywall per 1 thread. Total on the sheet accounts for 12 dowel-grooves (you can also 9). Similar

We put the nails on the threads and everything is ready to stick.

Next, we primer the wall, knead the glue, throw it with heaps on the wall along the perimeter and in the center of the sheet at a distance

about 25 cm, we carry out the installation of drywall and press the sheet with the rule to the nails. Actually everything. So glue one sheet after another. After about two hours you can

start puttying.

This method gives as a result an exact even wall. It is worth saying that if the wall is too crooked and the layers of glue can

exceed 5 cm, then you need to add additional pieces of drywall in such places, or use the method

assembly of the wall on the profile, since in this case it will turn out to be faster to collect than to paste. It’s nice to work!