Applying putty to the surface and LED lighting

For putty a wooden surface, you need to clean the surface from dust and dirt. Wet places of a wooden floor or wall need to be dried with a building hairdryer. If the area of ​​drying is small, then you can dry the ordinary household hairboard for the hair. Prepare a putty solution before using it, after preparing the surface and complete drying. The fact is that the putty solution quickly hardens in the open air. Therefore, it is better to prepare a putty solution in small portions.

Today, LED lighting is gaining great popularity. If you need LED backlight, we advise you to follow the link given. On the site you can also buy LED home tapes at favorable prices.

Put a putty to the surface with a spatula. If the cracks have significant sizes, then the solution is applied with several layers with a drying of the previous layer. The surface layer of putty is aligned with the surface. If a putty is performed with only one layer, then the putty layer must be applied with a small elevation above the floor, since the putty layer after drying gives a small shrinkage.

In the case when a multilayer putty is used with the drying of the previous layers, the surface layer of putty is leveled with the surface, since it will not give an shrinkage. The shrinkage was given all the previous layers of putty. After putty, the putty is grouting and stripping. Grouting and stripping is done with fine sandpaper. If, after stripping the sandpaper, the putty was given a sediment, then you need to apply a thin leveling layer of putty with subsequent stripping. After completely stripping and cleaning the surface from dust, a damp cloth can be painted with wooden coatings.